|
Direct Indent from the Manufacturer
Sheet, Coil, Strip & Circles
The most efficient way to purchase Flat Rolled Copper is direct from the manufacturer in the exact size & specification that you require. There are certain minimum criteria that must be met in order to buy this way, but the savings can be considerable. This guide can outline the basic requirements but we recommend that you contact our sales office to discuss your specific needs :-
Minimum Order Quantity : This will vary depending on your exact requirements, but in most cases the mills will accept a minimum of 1000 kgs per individual item.
Thickness Range : Currently we can buy Flat Rolled Brass products between
0.13mm - 4.00mm thick. Depending on their capabilities, the mill may impose some restrictions on the width to thickness ratio available.
Available Widths : The coil widths available range from 10mm - 1250mm wide depending on thickness. However, the mill may require a higher minimum quantity for widths that may leave them with excessive waste after slitting from standard 1000mm wide coils.
Available Tempers : Our suppliers offer the normal range of tempers :-
| Soft |
1/8 Hard |
¼ Hard |
½ Hard |
| ¾ Hard |
Hard |
Extra Hard |
Spring Temper |
Standards : Our suppliers manufacture to most major international standards. If you have specific requirements outside of those standards, we can enquire with the manufacturer on your behalf.
Lead Time : Most items will arrive in New Zealand approximately 4 months from time of order.
|
